Hey guys
With a heavy heart, I have decided to part with my Gavin (actually more like two Gavins) because of the slowly noticeable back.
Except for one of the motors (the brush board would have to be soldered and a magnet directed) there are parts for two Gavins.
The main scooter has a custom made aluminum rear, which was milled from a single piece of aluminum. As a result, this gavin is probably one of the few in the world that has no heat problems with the engine, even after 2-3 hours of continuous running.
In addition to the original batteries and the associated charger, I have a modern LiPo battery with almost 90 ampere hours, which allows runtimes of up to six hours. Of course, there is also a suitable charger for this
This is equipped with BMS and Bluetooth.
A temperature and humidity sensor with Bluetooth for the engine compartment is also installed.
Otherwise, there is:
1x Long tube with lid
2x short tube with lid
1x engine that needs new carbons but is otherwise in the best condition
1x engine that would have to be repaired as described
1x custom aluminum rear with plastic shroud
1x HDPE rear with carbon shroud
Both tail sections are equipped with t handle conversion, one even with a rod mechanism so that torn pull ropes for the trigger are a thing of the past.
2x complete propeller set
Various O-rings for everything multiple times
Otherwise, all spare parts and screws (sometimes difficult to get because there are no metric threads) are available several times. Various other small parts are also included.
If you are interested, I can provide more photos or information and, if desired, make a complete list of everything that is there.
If you are interested, I would also order new carbon brushes for the motor and install them, but then the whole thing becomes more expensive due to the price of spare parts and shipping.
Total desired price would be 2500EUR
16321 Bernau bei Berlin